Seattle artist, Jennifer Phillips, demonstrates her layering technique on Gessobord™, using oil paints and oil bars. I am always looking for ways to create subtle contrast between hard and soft edges in my work. While using a brush to create some of the softer applications of paint, I often use other tools like palette knives, needle tools, and oil bars to create my heavier textures. These materials work best on a firm support, therefore choosing the right substrate to paint on is very important. Unlike canvas, which can be flexible, Gessobord™ from Ampersand provides me with a strong rigid support that withstands a heavier hand and meets the demands of oil bars, palette knives, and texturing mediums. The surface also allows me to work in thinner washes and with soft blended brush strokes. The 2” Deep Cradle Gessobord, with its attractive wood sides, is gallery ready to hang and does not require framing, giving it a modern look when hanging on the wall.
Raw Umber oil bar to develop trees
Using a rag to wipe out shapes at the base of trees.
To begin this painting, I prepared a 16×20 Deep Cradle Gessobord by first taping off the natural wood edges with painters tape to keep the area clean. Using a palette knife, I applied a combination of Golden’s Molding Paste and Crackle Paste to the lower half of the board to give texture to the grassy field area. After it dried, I sealed it with Golden Soft Gel Medium and then gave the whole surface a layer of Daniel Smith Venetian Red Gesso. Portions of the red color peak through the final layers of my painting and unify the color palette. I then sketched in the composition using a dark brown Conte pencil. I developed the initial stages of the painting using a mixture of oil bar colors and a low toxicity mineral spirit called Daniel Smith Sol. I spread a wash of the spirits over the surface and then used a raw umber and burnt sienna oil bar to develop the tree forms (A). While the surface was still wet, I used a rag to wipe out shapes along the base of the trees to show soft light coming through (B).
Zinc white with Hansa yellow and ochre for sky
Reapplied oil bar with palette knife
Next, I used a variety of oil colors to blend in the sky and to create the soft edges of the tree tops (C). For the sky, I used a mixture of zinc white with hansa and yellow ochre for the warmer areas and raw umber for the cooler areas. I used mixtures of olive green and raw umber to create the trees in the distance, and then began to lay in the rich yellows of the distant field. At this point, I began defining the areas of light at the base of the trees using a mixture of hansa and yellow ochre, zinc white and a little raw umber. This was when I started refining the shapes and creating hard edge contrast. I did this by scraping paint away with a needle tool, drawing back into the surface to create a suggestion of branches. Then I went back and added delicate colored lines with a #4 script brush. Working dark to light, I focused on laying down initial layers of raw umber oil bar in the foreground and then, using a heavy hand, scumbling across the surface in a horizontal linear pattern with raw sienna oil bar. Subsequent colors of oil bar were used to build up the color and surface of the field. They were heavily applied to the surface, scraped away, and then reapplied using a palette knife (D). To finish, I used a #12 fan bristle brush to blend the trees and parts of the foreground. Once the painting was dry to the touch, I used a damar retouch spray to unify the surface of the painting. This varnish will allow the painting to continue drying until a final varnish is applied. I removed the tape that was protecting the sides of the Gessobord panel and my painting is now ready to hang! To learn more about artist Jennifer Phillips, visit www.facebook.com/JenniferPhillipsArt All things Ampersand, Karyn Meyer-Berthel Artist & Social Media Specialist Ampersand Art Supply Click here to explore the full selection of Ampersand panels and tools.